NACHI06041091

SERVICES

Inspections Offered

  • Buyer Inspection
  • New Construction Inspection
  • Builder Warranty Inspection
  • Out of Town Client Inspection
  • Problem-solving Inspection
  • Thermal Photography Inspection
  • Seller Inspection
  • New Construction Inspection

What is inspected?

Roof Structure

The type, style, layers, quality installation and more are checked. We will perform a diligent inspection of both sides of the roof. Attic ventilation and
insulation play an extremely important role in moisture, condensation, roof life and so much more – truly a key factor in how your home is functioning.

Foundation/Structure/Drainage:

We complete a thorough inspection on the inside
and the outside of the structure: foundation, crawl spaces, walls, doors, ceilings, and floors. Inadequate or reversed drainage and grading cause most water problems on a structure. Proper gutters and downspouts are another important factor in moisture control around the foundation.

Heating/Cooling

We look at the age, condition, and safety of each, and in most
cases, these are the most used appliances in the home. The wrong burn pattern and
moisture production in a gas furnace can cause premature heat exchanger failure
and possibly carbon monoxide.

Electrical

We check for double tapping of breakers, undersized wiring, unsecured
wiring, GFCI’s, AFCI’s, open ground or reversed polarity outlets, and much more!

“FLIP THIS HOUSE”
Will the quick flipper have this tested before and after the repairs?
Will you be the luck family to find out if they didn’t?

Is your home or potential new home a healthy environment for you and anyone else that enters it? I’ll do a Mold Assessment Inspection and Testing to give you the answer to that question.

Mold Assesment

Purpose: The purpose of the Mold Assessment is to detect the presence of a microbial problem in the inspected areas of the Subject Property.

Scope of Mold Assessment: The Mold Assessment consists of a visual inspection in readily accessible areas for mold and/or conditions that may indicate the presence of mold (“red flags”), for example, musty odor and/or evidence of water penetration. If the visual inspection shows no or one “red flag” area, then limited samples will be taken (“Initial Sampling”), as set forth in the “Initial Sampling” section below. If “red flags” are found in multiple areas, then You will be advised and offered the chance to have additional samples collected in any and all identified areas (“Additional Sampling”). Finally, if you so elect, the Inspector may only take samples in areas designated by the you (“Limited Mold Sampling”). The objective of the Mold Screen is to determine whether mold problems exist in the readily accessible area(s) sampled at the time the Mold Screen is performed. As such, the results of Mold Screen are not a guarantee that mold does or does not / will or will not exist in the house; the results are indicative only of the presence or absence of mold in the areas sampled at the time the Mold Screen is performed. In light of no currently established Threshold Limit Values (TLVs) for the majority of substances of biological origins that are associated with building-related exposures.

OVER 400 INSPECTION POINTS!

Foundations, Roofs & Gutters, Exterior Walls, Doors & Windows, Attic Insulation, Porches & Decks, Sidewalks & Driveways, Plumbing & Fixtures, Heating & Cooling Systems, Water Heater, Electrical Fixtures, Switches & Receptacles, Attic, Basement & Crawl Spaces, Electrical Service Panel, Floor Structures, Walls and Ceilings, Kitchen Appliances, and much more!


THERMAL IMAGING IS THE LATEST TOOL IN HOME INSPECTION

WHAT WILL YOUR INSPECTOR SHOW UP WITH (OR WITHOUT)?